Fluke I200S Current Clamp, BNC Adapter Adapter, 240 A ac AC Max, Voltage Output

This current clamp is an AC clamp probe designed to extend the current measurement range of scopes, power analysers and multimeters without interrupting circuits. It provides a voltage output via a safety-insulated BNC connector and includes an adaptor for connection to instruments with banana inputs. The clamp accepts single conductors and flat busbars, operates across a wide usable frequency band, and is intended for field and bench use in industrial environments.

• Dual ranges offering 20A and 200A with usable span
• 1.5% accuracy with added offset for precise readings
• Voltage output compatible with BNC-equipped instruments
• Measures up to 240A non-destructively for fault checks
• 2m cable for flexible connection to test equipment
• Accepts conductors up to 20x5mm for busbar work

• Suitable for load monitoring on control panels and switchgear
• Ideal for clamp-on current measurement during commissioning
• Used with DMMs for maintenance diagnostics on motors
• Can be used for HVAC current checks where Compact probes fit
• Used for power quality or waveform capture with scopemeters

It operates useably from 40Hz up to 10kHz, supporting mains and higher-frequency diagnostic measurements.

The probe has a safety-insulated BNC output and includes a dual-banana to BNC adaptor for meters with banana inputs.

The clamp can detect currents down to 0.1A in its lower range, suitable for light-load measurements.

It uses a single AA battery as its power source for internal electronics.

The device meets EN 61010 requirements and is rated to CAT III 600V for safe use on installation-level circuits.

EN61010, CAT III 600 V