FAG 625-2RSR-HLN 1 Row Ball Bearing - 5 mm ID, 16 mm OD

This ball bearing is a sealed, single-row deep-groove unit designed to support radial loads in Compact rotating assemblies. It is intended for use in high-speed electromechanical and automation components where a sealed, low-mass bearing with steel cage construction is required. The bearing operates effectively across typical ambient temperature ranges and is suitable for miniature shaft applications.

• Sealed 2RSR design prevents contaminant ingress and reduces maintenance
• Steel cage reduces mass while maintaining structural stability
• High limiting speed 31,500 rpm enables fast-rotating applications
• Dynamic load capacity 1.84 kN supports transient radial forces
• CN internal clearance permits precise axial positioning
• Steel raceways provide consistent rolling performance under load

• Suitable for high-speed motor spindles in automation equipment
• Ideal for miniature gearboxes in robotics and actuators
• Used with precision electronic cooling fans in servers and drives
• Can be used for rotary encoders in control systems
• Used for small pump shafts in fluid-handling devices

Ensure the shaft shoulder diameter exceeds the minimum mounting requirement of 7.4mm to permit correct axial location.

The bearing is rated for continuous operation between -30°C to 100°C, allowing use across common industrial climates.

The Basic static radial rating of 670 N defines resistance to non-rotational overloads and supports brief load events without permanent deformation.

The maximum allowable fillet on mating components is 0.3mm to avoid interference with the ring chamfer.