Weller XT H 0.8 mm Chisel 37 mm Soldering Iron Tip for use with WXP120, WP120

This soldering iron tip is a chisel‑shaped replacement designed for precision soldering tasks with compatible Weller irons. It serves as a direct consumable for maintenance and repair workflows, providing a defined contact edge suited to controlled thermal transfer in electronics work. The tip is UPC approved and intended for use with specific Weller handheld stations to restore functionality or adapt tool performance for fine solder joints.

• 0.8mm width delivers fine contact for delicate solder joints
• 37mm length provides extended reach into confined assemblies
• Chisel profile ensures consistent wetting across leaded joints
• Compatible design enables straightforward swap and secure fit
• Manufactured to match electrical soldering demands and durability

• Suitable for precision component soldering on small PCBs
• Ideal for rework of through‑hole and fine‑pitch leads
• Used with WXP120 stations for routine tip replacement
• Can be used in WP120 setups for electronics assembly tasks
• Suitable where narrow chisel geometry improves thermal control

It fits into the designated heating element of compatible handheld stations using the original retention method to ensure correct thermal coupling and electrical contact.

The flattened edge supports both point contact and broader wetting, making it suitable for bridging small pads and flowing solder along component leads.

The tip carries a UPC approval marking, which can be referenced during parts sourcing and inventory management.

Thermal transfer efficiency is governed by the contact area and alloy interface, so stable station temperature and correct tip seating are important for repeatable results.

Weller recommends the use of Weller-branded solder wire to achieve the best soldering performance and maximise the service life of your Weller soldering products.