수량

수량 선택 또는 입력

제품 정보를 선택해 유사 제품을 찾기

모두 선택	제품 정보	값
	브랜드	Telemecanique Sensors
	Product Type	Rope Pull Switch
	Contact Configuration	1 NO/1 NC
	IP Rating	IP66
	Number of Cable Entries	3
	Series	XY2CE
	Minimum Operating Temperature	-25°C
	Contact Current	3A
	E-Stop Button	Yes
	Reset Button	Yes
	Contact DC Voltage	250V dc
	Contact AC Voltage	240V ac
	Maximum Operating Temperature	70°C
	Depth	142mm
	Housing Material	Stainless Steel
	Width	105mm
	Standards/Approvals	UL 508, EAC, CSA, CCC, CSA C 22-2, EN/IEC 60947-5-5, UL (NISD)
	Length	229mm
	Hazardous Area Certification	ATEX
	Conduit Entry	M20
	Mechanical Life	60000Cycles

	모두 선택
	브랜드 Telemecanique Sensors
	Product Type Rope Pull Switch
	Contact Configuration 1 NO/1 NC
	IP Rating IP66
	Number of Cable Entries 3
	Series XY2CE
	Minimum Operating Temperature -25°C
	Contact Current 3A
	E-Stop Button Yes
	Reset Button Yes
	Contact DC Voltage 250V dc
	Contact AC Voltage 240V ac
	Maximum Operating Temperature 70°C
	Depth 142mm
	Housing Material Stainless Steel
	Width 105mm
	Standards/Approvals UL 508, EAC, CSA, CCC, CSA C 22-2, EN/IEC 60947-5-5, UL (NISD)
	Length 229mm
	Hazardous Area Certification ATEX
	Conduit Entry M20
	Mechanical Life 60000Cycles

Telemecanique XY2CE & XY2CB Emergency Stop Rope Pull Switches

These emergency stop trip wire switches are designed to reduce the risk of injury to persons and damage either to machines or work in progress. They can be tripped by a single human action when a normal emergency stop function is not available and will also trip in the event of the trip wire breaking.

Switches incorporate positive opening operation contacts, the tripping of the switch being made with positive action

The switch latches in the tripped position (N/C safety contact(s) open). The function of the N/O contact is purely for signalling

Incorporates a reset button, which re-closes the safety contact(s), restarting of the machine must only be achieved by manual operation of a control device within the machine start circuit, remote to the trip wire switch

Recommended distance between cable supports is 15m (for model XY2-CB30 a distance of 20m is recommended)

The XY2 CE1A296 comes with a pilot light (direct supply)

Note

The XY2 CB switch must not be used if the installation requires that the trip wire be angled but the XY2 CE switch can. In this case, the total sum of the angles through which the trip wire bends must not exceed 180°.

Standards

EN/ISO 13850:2006

Telemecanique Sensors XY2CE Rope Pull Switch 229 mm, 1 NO/1 NC

Telemecanique XY2CE & XY2CB Emergency Stop Rope Pull Switches

Note

Standards

관련된 링크들