INA PSHE30-XL-N Plummer Block House -, 30 mm ID

This plummer Block house provides a cast iron mounted bearing housing designed to support rotating shafts in industrial assemblies. It accommodates a 30 mm bore bearing and positions the shaft at a 42.9 mm centre height for alignment in driven or idler applications. The housing incorporates two mounting bolts and is intended for installations requiring a rigid, sealed support for radial loads.

• Full-complement needle roller set offers high radial load capacity
• Plastic plain washers on both sides reduce axial friction
• Drive-fit lubrication nipple enables convenient relubrication access
• Stud-type roller design provides integrated axial guidance
• Rated for continuous lubrication operation at 2600 r/min

• Suitable for conveyor idler and guide roller supports
• Used with shaft assemblies requiring axial guidance
• Ideal for transfer equipment in material handling lines
• Can be used for Compact machine tool auxiliary rollers

The housing features M10x1 threaded stops with a 12 mm thread length.

The nut should be tightened to 15 Nm to secure the stud effectively.

A NIPA1X4,5 drive-fit lubrication nipple is fitted to allow periodic grease replenishment.

Continuous operation is specified up to 2600 r/min when greased appropriately.