Fluke FTPL-1 Fused Test Probe Lead, CAT III, CAT IV, 10A

모든 Multimeter Leads 열람하기

Subtotal (1 unit)*

₩327,132.00

Add to Basket
수량 선택 또는 입력
재고있음
  • 33 개 단위 배송 준비 완료
  • 추가로 2026년 6월 04일 부터 13 개 단위 배송
  • 추가로 2026년 6월 18일 부터 12 개 단위 배송
더 자세한 내용이 필요하신가요? 필요한 수량을 입력하고 '배송일 확인'을 클릭하면 더 많은 재고 및 배송 세부정보를 확인하실 수 있습니다.
수량
한팩당
1 +₩327,132.00

* 참고 가격: 실제 구매가격과 다를 수 있습니다

RS 제품 번호:
880-1397
Distrelec 제품 번호:
176-00-063
제조사 부품 번호:
FTPL-1
제조업체:
Fluke
제품 정보를 선택해 유사 제품을 찾기
모두 선택

브랜드

Fluke

Lead Type

Test Probe Lead

Product Type

Multimeter Leads

Current

10A

Connector Type

Straight, Right Angle

Fused

Yes

Lead Length

1.5m

Safety Category Voltage

1000, 600V

Minimum Operating Temperature

-20°C

Maximum Operating Temperature

50°C

Safety Category Level

CAT III, CAT IV

Standards/Approvals

No

제외

COO (Country of Origin):
TW

Fluke Multimeter Leads, 1.5m Lead Length, 10A Current - FTPL-1


This multimeter leads set provides fused test probes and silicone-insulated leads for safe voltage and continuity measurements in industrial environments. Designed for use where category-rated protection and clear live-voltage indication are required, the set pairs modular probes with a combination of straight and right-angle connectors and removable tip accessories for targeted probing.

Features & Benefits


• Built-in fuses rated 11A with 20kA interrupt limit for added protection
• Probes indicate live voltage even when a fuse has blown to avoid false zero readings
• 2mm threaded tips with removable 4mm spring contacts for flexible contact options
• Right-angle on one end and straight connector on the other for access in tight spaces
• Silicone-insulated 1.5m leads resist extremes from -20°C to 50°C for field use

**Applications**


• Suitable for on-site fault finding in electrical distribution panels
• Ideal for measurements on control systems in automation environments
• Used for component testing in electronics assembly and repair
• Can be used for diagnostic work on mechanical plant with limited probe clearance

How can I verify the fused probe before taking current measurements?


Check probe continuity with the meter

a fused probe must show continuity to enable current mode since the fuse disables current measurement when open.

Are the probe tips adaptable for probing closely spaced contacts?


Yes, the threaded 2mm tips accept removable insulated caps and 4mm spring contacts to reduce exposed metal and adapt to tight pitches.

What happens to voltage indication if a fuse opens during a live test?


The probes still permit an approximate voltage reading through the meter input impedance, but results vary by meter and should be confirmed by a continuity check.

What electrical categories and voltages do these leads support?


They are rated for CAT III at 1000V and CAT IV at 600V and for use up to a 10A continuous current rating.

관련된 링크들