Electromen OY, 10V, 35 V, 15A DC Motor Controller, PWM Function

모든 Motor Controllers 열람하기

Subtotal (1 unit)*

₩201,800.00

Add to Basket
수량 선택 또는 입력
재고있음
  • 17 개 단위 배송 준비 완료
더 자세한 내용이 필요하신가요? 필요한 수량을 입력하고 '배송일 확인'을 클릭하면 더 많은 재고 및 배송 세부정보를 확인하실 수 있습니다.
수량
한팩당
1 +₩201,800.00

* 참고 가격: 실제 구매가격과 다를 수 있습니다

RS 제품 번호:
183-7332
제조사 부품 번호:
EM-241B-PLI
제조업체:
Electromen OY
제품 정보를 선택해 유사 제품을 찾기
모두 선택

브랜드

Electromen OY

Product Type

DC Motor Controller

Control Function

PWM

Supply Voltage

10V, 35V

Output Voltage

35V

Current Rating

15A

Overall Length

42mm

Overall Width

72mm

Overall Depth

25mm

Minimum Operating Temperature

-40°C

Maximum Operating Temperature

60°C

Standards/Approvals

EN - 55022B

COO (Country of Origin):
FI

Electromen - EM-241PLI DC MOTOR POSITION CONTROLLER, 12-24 V DC, 15 A


The EM-241-PLI is a full bridge brushed DC-motor starter.It is designed to work in a wide range of applications and offers a host of adjustments to optimise control for each application.The drive has adjustable acceleration and deceleration ramps to produce smooth starts and stops,adjustable current limit protects motor against overcurrent and can also be used to provide an end-stop on current trip

The PLI version has a PULSE COUNTER which can be used to define end stops - the count setting is stored in non-volatile memory

This device has also two settable speeds, which are useful in positioning applications

Control inputs are present for basic forward, backward and stop commands, as well as limit switch inputs to define end stops

This device has also two settable speeds, this can be activated by dedicated input. The same input can be used for analogue speed control signal 0-5V

Fault output can indicate current trip, over-current or zero-current conditions. It can also be pulled down to ground to disable the drive, if required

C-version includes wo new parameter: freewheel options for release the rotor of motor, selectable pwm frequency (16kHz pwm being inaudible though current handling capacity is reduced)

There are two selectable control modes, in continuous mode the motor runs as long as the control is active, in impulse mode it will operate from a momentary command

Special settings are also available for start-up kick and auto reverse

For parameters setting there are 3 options: EM-236 interface unit, EM-268 with Menthol-Lite PC-program and EM-326 with Menthol-App application for smartphone;Small size with high current output

2ch pulse counter inputs

Pulse counter limits.

Current limit 0.1-20A (30A at start up)

Zero current limit

Overvoltage brake

Speed setting

Flexible control inputs

impulse / continuous mode

DIN rail mountable

Programmable parameters to suit application

* Continuous current output when ambient temp is <50°C )

15A at 100% speed / 10A at 5-99% speed pwm=2kHz

Peak ( 5s.) 30A at 2khz PWM

관련된 링크들