Oscilloscope Probes

An oscilloscope is considered to be the most used instrument for electrical engineers who need to measure electrical characteristics of electronic devices but you also need at least one probe.
Things to consider when choosing probes
• Ensure the probe's input connector matches the connector on your scope
• Choose a probe whose input resistance and capacitance match the input resistance and capacitance of your scope - matching is critical for guaranteeing proper signal transfer and signal accuracy
The best approach, for matching a probe with a scope, is to first choose a probe whose capacitance is within the range of your scope and then fine-tune the probe's capacitance by adjusting its compensation network using the probe's trimmer capacitor.
The 1X probes are suitable for many low frequency applications. They typically offer the same input impedance of the oscilloscope which is normally 1 M Ohm. The most common type of probe with a built in attenuator gives an attenuation of ten, and it is known as a 10X oscilloscope probe
Types of probes
Passive probes are the most commonly used probes for taking measurements. They are easy to use, relatively inexpensive, and fairly rugged. Available in the following configurations:
• 1´: no attenuation
• 10´: factor-of-10 attenuation
• 100´: factor-of-100 attenuation
• 1000´: factor-of-1000 attenuation
Attenuation probes serve to multiply the voltage measurement range of the oscilloscope by using an internal resistor that, when used in conjunction with the input resistance of the scope, creates a voltage divider. Useful for the following reasons:
• It allows for the measurement of a signal that might exceed the limits of the oscilloscope.
• The attenuation circuitry results in higher resistance and lower capacitance, which is important for high-frequency measurements.
Active probes contain active components, such as FETs or amplifiers. Commonly used for taking high-speed measurements (>500 MHz) or on high-impedance circuits. One limitation is their limited voltage range.
Differential probes are popular for measuring high-frequency signals or signals of very low amplitude.
A current probe measures the electrical current flowing through a conductor.
Tips
• Always use an appropriate probe tip and/or probe tip adapter whenever possible
• Keep ground leads short

...
Read more Read less

검색 필터링

총 202개 제품 중 81번째-100번째 제품을 조회 중
한장내 검색 결과 수
제품설명 단가 Probe Type Attenuation Bandwidth Maximum Common Mode Input Voltage Connector Type Model Number p Number of Probes Safety Category Level Safety Category Voltage Series Safety Category Rise Time
RS 제품 번호 179-9563
제조사RS PRO
₩62,908.30
Each
수량
Passive 10:1 200MHz - BNC - 1 CAT II 400 Vrms RS-TP CAT II 400Vrms <1.75ns
RS 제품 번호 922-5255
제조사 부품 번호PP023-1
제조사Teledyne LeCroy
₩507,625.00
Each
수량
Passive 1:10 500MHz - BNC PP023 1 CAT I, CAT II 400 Vrms, 500 Vrms - CAT I 500 Vrms, CAT II 400 Vrms 700ps
신제품
RS 제품 번호 201-1881
제조사 부품 번호RT-ZS60
제조사Rohde & Schwarz
₩9,117,072.10
Each
수량
- 10:1 6GHz - BNC RT-ZS - - - - - -
RS 제품 번호 715-8743
제조사 부품 번호TPP0201-PK10
제조사Tektronix
₩946,037.85
1 Pack of 10
Pack(s)
Passive 1:10 200MHz 300V BNC TPP0201 - CAT I, CAT II 300 V, 300 V ac, 400 V ac TPP CAT I 400 V ac, CAT II 300 V, CAT II 300 V ac 2.3ns
RS 제품 번호 725-6604
제조사 부품 번호P6139B
제조사Tektronix
₩835,578.65
Each
수량
Passive 1:10 500MHz - BNC P6139B - CAT II 300V - CAT II 300 V -
RS 제품 번호 702-3906
제조사 부품 번호N2874A
₩633,578.00
Each
수량
Passive 1:10 1.5GHz - BNC N2874A - CAT I 8.5V N2870A CAT I 8.5V -
RS 제품 번호 179-9558
제조사RS PRO
₩66,312.10
Each
수량
Passive 10:1 350MHz - BNC - 1 CAT II 400 Vrms RS-TP CAT II 400Vrms <1ns
RS 제품 번호 501-180
제조사 부품 번호10072A
₩241,694.60
Each
수량
Gripper - - - - 10072A - - - - - -
신제품
RS 제품 번호 201-1879
제조사 부품 번호RT-ZS20
제조사Rohde & Schwarz
₩3,483,631.20
Each
수량
- 10:1 1.5GHz - BNC RT-ZS - - - - - -
RS 제품 번호 878-7610
제조사 부품 번호ZS1500
제조사Teledyne LeCroy
₩3,086,501.05
Each
수량
Active 1:10 1.5GHz - ProBus ZS1500 2 - - ZS - -
RS 제품 번호 738-9366
제조사 부품 번호ZD1000
제조사Teledyne LeCroy
₩6,943,973.65
Each
수량
Active, Differential 1:1 1.2GHz 10V - ZD1000 - - - ZD - 375ps
RS 제품 번호 851-3090
제조사 부품 번호PP019-1
제조사Teledyne LeCroy
₩230,099.05
Each
수량
Passive 1:10 250MHz - BNC PP019-1 - CAT I, CAT III 600 Vrms, 1500 V PP019 CAT I 1500 V, CAT III 600 Vrms 1.4ns
RS 제품 번호 174-8867
제조사 부품 번호HVD3102A
제조사Teledyne LeCroy
₩2,645,701.20
Each
수량
Differential 1:100, 1:1000 25MHz 600V - - 1 CAT III - HVD3000A CAT III 1000 Vrms 14ns
RS 제품 번호 134-6157
제조사 부품 번호N2142A
₩78,856.25
Each
수량
Passive 1:1, 1:10 75MHz - BNC 1000/3000 X-Series 1 CAT II 150 Vrms, 300 Vrms InfiniiVision CAT II 150 Vrms, CAT II 300 Vrms -
RS 제품 번호 745-0708
제조사 부품 번호PPE5KV
제조사Teledyne LeCroy
₩1,273,635.00
Each
수량
High Voltage, Passive 1:100 400MHz - BNC PPE5KV - CAT I - PEE CAT I -
RS 제품 번호 174-8870
제조사 부품 번호HVD3106A-6M
제조사Teledyne LeCroy
₩3,901,740.60
Each
수량
Differential 1:50, 1:500 80MHz 6kV - - 1 CAT III - HVD3000A CAT III 1000 Vrms 4.4ns
RS 제품 번호 712-1141
제조사 부품 번호P5122
제조사Tektronix
₩516,669.25
Each
수량
High Voltage, Passive 1:100 200MHz - - P5122 - CAT II 600 V ac, 1000 V ac TPS2000 CAT II 1000 V ac, CAT II 600 V ac 2.2ns
신제품
RS 제품 번호 201-1874
제조사 부품 번호RT-ZHD15
제조사Rohde & Schwarz
₩2,855,950.95
Each
수량
High Voltage 50:1/500:1 100MHz - BNC RT-ZHD - - - - - -
RS 제품 번호 179-9556
제조사RS PRO
₩74,545.70
Each
수량
Passive 1:1 and 10:1 Switchable 350MHz - BNC - 1 CAT II 400 Vrms RS-TP CAT II 400Vrms <35ns
RS 제품 번호 898-6781
제조사 부품 번호TA222
제조사Pico Technology
₩1,372,776.10
Each
수량
Active 1:10 1.5GHz 20V BNC, SMA adapter - 2 - 20V - - -