RS PRO D-Shackle, Stainless Steel, 0.75t

We are proudly introducing our own branded RS PRO Stainless-Steel D Shackle recognisable as they are narrower than a Bow Shackle and, in most cases, they have a threaded pin or pin close. The purpose of their existence is to serve for an in-line load, which explains why the loop is so small.
The material of this D-Shackle is stainless-steel meaning it can be subjected to climatic factors. This D-Shackle (known as Chain Shackle) with 10 mm diameter, withstands of approximately 0.75 ton is a perfect solution to secure your light to moderate loads.
Note: Suitable for a wide variety of applications such as tensioning wires or securing loads. Not suitable for lifting applications.

• Stainless-Steel Shackle with crew pin
• The D Shackle comes with 3-year Warranty
• Pin diameter of 16 mm
• Jaw width of 31 mm
• This Chain Shackle deals well with weather conditions
• Ideal for securing light to moderate loads or plant
• Suitable applications such as tensioning wires or securing loads

• Shackles are used in conjunction with slings and rope
• Wire Rope Slings
• Industrial crane rigging onboard large ships
• Commonly used in personal safety gear including climbing and mountaineering harnesses
• Vehicle recovery

What are the widely accepted codes of practice when dealing with Shackles?

• Always perform regular check inspection


• Pay attention to the manufacturer or distributor specifications


• Use the correct size of the Shackle for the hook or sling straps


• Make sure to connect multiple sling legs to the body of the Shackle, and never to the pin itself


• Never use the Shackle to lift if it does not meet the required safety standards or shows signs of excessive wear

RS Pro is our family brand and brings you a wide range of high-quality and high-value products to support your project. Trusted by engineers all over the world, every part of every RS PRO product is always rigorously tested against demanding industry standards. We are only giving the RS PRO seal of approval if we're confident of their exceptional quality, which means you can be convinced too.

This is not for lifting applications.

Avoid exceeding 120 degrees for the angle when there is a requirement to use multiple-leg slings.