Phoenix Contact MINI MCR Series Signal Conditioner, DIN Rail

모든 Interface Modules 열람하기

Subtotal (1 unit)*

₩1,546,080.00

Add to Basket
수량 선택 또는 입력
재고있음
  • 추가로 2026년 9월 21일 부터 4 개 단위 배송
더 자세한 내용이 필요하신가요? 필요한 수량을 입력하고 '배송일 확인'을 클릭하면 더 많은 재고 및 배송 세부정보를 확인하실 수 있습니다.
수량
한팩당
1 +₩1,546,080.00

* 참고 가격: 실제 구매가격과 다를 수 있습니다

RS 제품 번호:
652-8324
Distrelec 제품 번호:
303-17-012
제조사 부품 번호:
2708339
제조업체:
Phoenix Contact
제품 정보를 선택해 유사 제품을 찾기
모두 선택

브랜드

Phoenix Contact

Product Type

Signal Conditioner

Mount Type

DIN Rail

Minimum Operating Temperature

-20°C

Maximum Operating Temperature

60°C

Standards/Approvals

EMC Directive 2004/108/EC, cULus Listed, ATEX, EN 55011, CE-, EN 61000-6-2:2005, cULus Recognised

Series

MINI MCR

COO (Country of Origin):
DE

Phoenix Contact Fibre Optic Converter, DIN Rail Mount - PSI-MOS-RS485W2/FO 850 E - 2708339


Use this Fibre optic converter from Phoenix Contact for interference-free communication between devices in an ethernet system. It connects copper-based cabling systems to Fibre optic networks for the swift and uninterrupted transfer of data.

The converter is completely immune to outside electrical interference to enhance the performance and safety of your system. It's able to bridge long distances while maintaining a fast data transmission rate. The unit includes connection monitoring that constantly ensures no signals are lost without the operator being aware of a fault. Bright LEDs (light-emitting diodes) give a clear and quick Visual indication of its operational status.

This unit is suited to DIN rail mounting and has a small and Compact design to improve packing efficiency in your control system. Its enclosure is IP20 (ingress protection) rated which means the converter is safely protected from touch and large dirt particles.

• ATEX-approved for use in areas where explosive atmospheres may occur

• Pluggable screw connection for secure installation

• Low typical current consumption of 120mA (24V DC)

Fibre Optic Converters


Industrial modules that enable conversion of RS232, RS422, RS485, CAN, CANopen and deviceNET communication supports to an 850 Nm Fibre Optic connection.

A diagnostic system monitors the Fibre optic section. This allows the line status to be signalled via LEDs placed on the front and via an output switch, which is activated when the connection is critical.

Fibre optic connection with B-FOC(ST®) or FSMA and MINICONEC screw Terminal for the copper part and D-sub 9 for the PROFIBUS version.

Operating temperature: -20 °C → 60 °C

DIN rail assembly.

관련된 링크들