Omron Slave Connector for Use with Digital Fiber Amplifier

For use with Omron E32 Fibre Optic Cable

Single NPN or PNP output versions, available with or without an additional 1 to 5Vdc analogue output

The analogue output can be used for alarm state to signify dirt build up. Is scaleable across the set-point and actual value, to give a true state of material left on a drum feed for example

High speed, standard, and long range modes to cover most applications

Has programmable settings, such as off delay timer, peak hold, hysteresis adjustment and alignment aid

Pre-wired versions for single application. Connector versions for multiple amplifier applications to provide wire and connection saving. Up to 16 amplifiers from one power supply. Master (power and output) and Slave (output only) connectors, available separately see stock nos. 378-8618, 378-8624

See stock nos. 340-976 and 340-960 for suitable fibre optic sensing heads

Supply voltage (Vdc): 10 to 24 ±10%

Switching Current (mA): 50

Sensing Distance is typically: 400mm (DC200) 950mm (TC200)

Light On/Dark On selectable

Uses integrated optical link for upload and download of parameter settings from hand held programmer. Optical link allows the locking out of some or all of the settings to provide a tamperproof configuration

Short Circuit and reverse polarity protection

Mutual interference protection for up to 10 amplifiers for close mounting of fibres for profiling or positioning applications

Operating temperature range -25° to +55° for 1 to 3 Amplifiers together, +50°C for 4 to 11, and 45°C for 12 to 16.

Response times shown are for high speed mode, standard mode and long distance mode respectively

Dimensions (mm): 10 x 67.3 x 31.5 WDH (E3X-DA44V is 12 x 81 x 33 WDH, 81 is excluding connection)