United Automation, DMFC36, Thyristor Trigger Module, 24V ac, 50 → 60Hz, 9-Pin, 160 x 62 x 62mm

참조 문서
제정법과 컴플라이언스
제품 세부 사항

Multi Mode, Phase-Angle & Single/Dual Cycle Burst Firing Circuit, DMFC-36

The DMFC-36 module has been designed to offer Phase-Angle or Burst Fire Control in firing a thyristor assembly or complete thyristor controller for driving resistive loads. In Single-Cycle or Dual-Cycle mode, these modules use the fastest burst rates possible, providing very accurate control and minimising Harmonic distortion & Flicker within the system.

Includes a Transformer
Standard Din Rail Mount
On Board Indication of Power, Burst-Rates & Fault Conditions
Phase-Angle, or Burst Fire Control
Single-Cycle / Dual Cycle Burst Fire modes of control or adjustable Standard Burst Firing
Soft-start (1 to 30 seconds)
Inhibit Input
Wide Range of Control Options: 0-5V, 0-10V, 1-5V, 2-10V, 0-20mA, 4-20mA, Manual Potentiometer
Isolated Pulse transformer outputs
On Board Protection Fuse

The number of complete mains cycles during fixed repeating periods (typically 1 to 10 seconds) is varied, thus altering the duty cycle or on-/off-time ratio. Trigger pulses coincide with the zero-crossing times of the mains supply thus ensuring no RFI is produced when using resistive loads.

Input Voltage DC 24V dc
Input Voltage AC 24V ac
Output Isolation 3.5kV
Mounting Type DIN Rail
Pin Count 9
Dimensions 160 x 62 x 62mm
Length 160mm
Height 62mm
Width 62mm
Maximum Operating Frequency 60 Hz
Maximum Operating Temperature +65 °C
Minimum Operating Frequency 50Hz
Minimum Operating Temperature 0 °C
1 <재고있음> 5-9영업일내 홍콩 발송
단가 Each
(exc. VAT)
1 - 2
3 +