Fluke Test Probe, 60V

All accessories are tested to 60Vdc

• Durable connection, which guarantees excellent results
• Fantastic electronic set
• CAT II 300 V
• Insulated wires

These leads are connecting cables which are used specifically for Multimeters, attaching a test probe to the end will allow the user to measure the required voltage, current or electrical resistance. As it assists operation with a multimeter, at least two of these types of electrical values are measured.

Banana jack accepts standard DMM and banana leads
Non-rotating banana jack prevents leads from tangling, allowing you to tighten/loosen clamp while still connected to the test lead
Available for 4mm input, modular connection withTP81

Banana jack accepts DMM and banana jack leads
Non-rotating banana jack prevents leads from tangling, allowing you to tighten/loosen clamp while still connected to the test lead

Slides onto test probes measuring 2mm

Looking for precision testing that measures up? FLUKE has got you covered with these test probes. They're rigid back pins that slide onto 2mm probes and are used to make contact with a circuit or component for testing or measurement purposes. You'll find them used in the calibration of automotive electrical systems, such as sensors and ignition systems. The sharp, pointed tip can easily penetrate insulation, so you can be sure of accurate and consistent measurements.

• Insulated pin protects against short-circuiting
• Safety category voltage of 60V provides safety against electric shocks
• Black and red colours are easy to identify

• Automotive systems
• Telecommunications
• Medical devices
• Power generation and distribution

The probes are two inches long. This short size is a reliable way to reduce the signal interference or noise that you might experience when using longer devices.

The stainless steel probes are resistant to corrosion and impacts, so you can rest assured they can stand up to the demands of harsh industrial settings.