- RS 제품 번호:
- 750-8885
- 제조사 부품 번호:
- UCFL207
- 제조업체:
- RS PRO
일시 품절-다음 입고 날짜는 07/05/2024 (일/월/년) 이며, 그 후 5-10영업일내 홍콩에서 발송. 정확한 입고 수량에 대한 문의는 krenquiry@rs-components.com 로 연락주세요.
추가완료!
단가 개당
Was ₩39,063.81
귀하의 지불
₩18,513.352
수량 | 한팩당 |
1 + | ₩18,513.352 |
- RS 제품 번호:
- 750-8885
- 제조사 부품 번호:
- UCFL207
- 제조업체:
- RS PRO
참조 문서
제정법과 컴플라이언스
해당 안됨
- COO (Country of Origin):
- CN
제품 세부 사항
RS PRO Two Hole Flange Bearing Unit 35 mm ID
If you need to stop your ball bearings from sliding out of place, use this RS PRO two-hole flange bearing unit. It's most often used in commercial settings, such as boat yards, factories and construction sites.
This bearing is built for maximum longevity as it's made of cast iron, which doesn't rust or tarnish. The material is also strong enough to resist high vibrations and large axial loads. The component can handle a moderate level of misalignment, so there's no need to worry if your joints aren't perfectly aligned.
There are two pre-drilled mounting holes on the bearing, so it's quick and easy to install. Flange bearings such as this one are often used in food-processing machinery and heating, ventilation and air-conditioning (HVAC) equipment.
This bearing is built for maximum longevity as it's made of cast iron, which doesn't rust or tarnish. The material is also strong enough to resist high vibrations and large axial loads. The component can handle a moderate level of misalignment, so there's no need to worry if your joints aren't perfectly aligned.
There are two pre-drilled mounting holes on the bearing, so it's quick and easy to install. Flange bearings such as this one are often used in food-processing machinery and heating, ventilation and air-conditioning (HVAC) equipment.
Features and Benefits
- Flange-bearing unit
- Depth of 44.4 mm
- Inside diameter of 35 mm
- Length of 161 mm
- Width of 90 mm
- Cast-iron material
- Two mounting holes
- Mounting hole centre-to-centre of 130 mm
- Mounting hole size of 16 mm
사양
속성 | 값 |
---|---|
Inside Diameter | 35mm |
Bearing Unit Type | Flange Bearing Unit |
Number of Mount Holes | 2 |
Material | Cast Iron |
Length | 161mm |
Width | 90mm |
Depth | 44.4mm |
Mount Hole Size | 16 mm |
Mount Hole Centre-to-Centre | 130mm |