Oscilloscope Probes

An oscilloscope is considered to be the most used instrument for electrical engineers who need to measure electrical characteristics of electronic devices but you also need at least one probe.
Things to consider when choosing probes
• Ensure the probe's input connector matches the connector on your scope
• Choose a probe whose input resistance and capacitance match the input resistance and capacitance of your scope - matching is critical for guaranteeing proper signal transfer and signal accuracy
The best approach, for matching a probe with a scope, is to first choose a probe whose capacitance is within the range of your scope and then fine-tune the probe's capacitance by adjusting its compensation network using the probe's trimmer capacitor.
The 1X probes are suitable for many low frequency applications. They typically offer the same input impedance of the oscilloscope which is normally 1 M Ohm. The most common type of probe with a built in attenuator gives an attenuation of ten, and it is known as a 10X oscilloscope probe
Types of probes
Passive probes are the most commonly used probes for taking measurements. They are easy to use, relatively inexpensive, and fairly rugged. Available in the following configurations:
• 1´: no attenuation
• 10´: factor-of-10 attenuation
• 100´: factor-of-100 attenuation
• 1000´: factor-of-1000 attenuation
Attenuation probes serve to multiply the voltage measurement range of the oscilloscope by using an internal resistor that, when used in conjunction with the input resistance of the scope, creates a voltage divider. Useful for the following reasons:
• It allows for the measurement of a signal that might exceed the limits of the oscilloscope.
• The attenuation circuitry results in higher resistance and lower capacitance, which is important for high-frequency measurements.
Active probes contain active components, such as FETs or amplifiers. Commonly used for taking high-speed measurements (>500 MHz) or on high-impedance circuits. One limitation is their limited voltage range.
Differential probes are popular for measuring high-frequency signals or signals of very low amplitude.
A current probe measures the electrical current flowing through a conductor.
Tips
• Always use an appropriate probe tip and/or probe tip adapter whenever possible
• Keep ground leads short

...
Read more Read less

검색 필터링

총 202개 제품 중 21번째-40번째 제품을 조회 중
한장내 검색 결과 수
제품설명 단가 Probe Type Attenuation Bandwidth Maximum Common Mode Input Voltage Connector Type Model Number p Number of Probes Safety Category Level Safety Category Voltage Series Safety Category Rise Time
RS 제품 번호 661-3295
제조사 부품 번호P6316
제조사Tektronix
₩976,678.25
Each
수량
Logic, Passive - - - - P6316 - - - - - -
RS 제품 번호 898-6769
제조사 부품 번호TA058
제조사Pico Technology
₩594,429.65
Each
수량
Active, Differential 1:10 50MHz 600V - - 2 CAT I ±700 V, 600 Vrms - CAT I ±700 V, 600 Vrms -
RS 제품 번호 716-7419
제조사 부품 번호VPS420-R
제조사Fluke
₩438,650.00
Each
수량
Passive 1:100 150MHz - - VPS420 R 1 CAT III 2000V ScopeMeter 190 CAT III 2000 V -
RS 제품 번호 518-0993
제조사 부품 번호99.00224
제조사Staubli
₩54,561.55
1 Set
Set(s)
Passive 1:10 150MHz - BNC 99.00224 - CAT II 1000V - CAT II 1000 V 1.2ns
RS 제품 번호 448-4351
제조사 부품 번호15120
제조사Testec
₩678,723.30
Each
수량
Active, Differential 1:100, 1:1000 100MHz 1kV BNC TT-SI 9110 - CAT III 1000 V ac, 1400 V ac/dc SI CAT III 1000 V ac, CAT III 1400 V 3.5ns
RS 제품 번호 830-3212
제조사 부품 번호WS3K-MSO
제조사Teledyne LeCroy
₩2,554,892.90
Each
수량
- - 500MHz 30V - WS3K-MSO - - - WaveSurfer 3000 Series - -
RS 제품 번호 512-6078
제조사 부품 번호TT-SI 9010
제조사Testec
₩1,299,803.65
Each
수량
Active, Differential 1:100, 1:1000 70MHz 5kV BNC TT-SI 9010 - CAT I, CAT II 2500 V ac, 7000 V ac/dc SI CAT I 2500 V ac, CAT II 7000 V ac/dc 5ns
RS 제품 번호 714-0039
제조사 부품 번호10073D
₩574,040.95
Each
수량
Passive 1:10 500MHz - BNC 10073D - CAT II 400V - CAT II 400 V 700ps
RS 제품 번호 702-3895
제조사 부품 번호N2870A
₩348,334.60
Each
수량
Passive 1:1 35MHz - BNC N2870A - CAT II 55V N287XA CAT II 55V -
RS 제품 번호 800-3004
제조사 부품 번호TPP0051
제조사Tektronix
₩46,321.75
Each
수량
Passive 1:10 50MHz - BNC TPP0051 1 CAT II 300V - CAT II 300 V 7ns
RS 제품 번호 801-4868
제조사 부품 번호AP031
제조사Teledyne LeCroy
₩785,510.55
Each
수량
Differential 1:10, 1:100 25MHz 700V BNC AP031 - CAT III 1000V - CAT III 1000 V 14ns
RS 제품 번호 796-6702
제조사 부품 번호P6015A
제조사Tektronix
₩3,661,650.25
Each
수량
High Voltage 1:1000 75MHz 20kV - P6015A 1 - - - - 4ns
RS 제품 번호 796-6718
제조사 부품 번호P6247
제조사Tektronix
₩8,812,804.00
Each
수량
Differential 1:1, 1:10 1GHz 25V BNC P6247 1 - - - - 350ps
RS 제품 번호 726-0041
제조사 부품 번호TPP0201
제조사Tektronix
₩114,222.60
Each
수량
Passive 1:10 200MHz 300V BNC TPP0201 - CAT I, CAT II 300 V, 300 V ac, 400 V ac TPP CAT I 400 V ac, CAT II 300 V, CAT II 300 V ac 2.3ns
RS 제품 번호 734-5022
제조사 부품 번호P5202A
제조사Tektronix
₩2,672,424.75
Each
수량
Differential, High Voltage 1:20, 1:200 100MHz 640V - P5202A - CAT I, CAT II 300 V, 450 V P52XXA CAT I 45 V, CAT II 300 V -
RS 제품 번호 901-0970
제조사 부품 번호PK400-0
제조사Teledyne LeCroy
₩342,957.65
Each (In a Pack of 22)
수량
Gripper - - - - - 22 - - - - -
RS 제품 번호 384-878
제조사 부품 번호VPS210-R
제조사Fluke
₩379,484.95
Each
수량
Passive 1:10 200MHz - - VPS210 5 CAT II, CAT III 30 V, 600 V, 1000 V ScopeMeter 190 CAT II 1000 V, CAT II 3 V, CAT III 600 V -
RS 제품 번호 879-3851
제조사 부품 번호DOX-MSO3LA
제조사Metrix
₩1,020,086.00
Each
수량
Logic - 20MHz - - DOX-MSO3LA 1 CAT I 300V DOX3000 CAT I 300 V -
RS 제품 번호 898-6820
제조사 부품 번호TA133
제조사Pico Technology
₩261,717.50
Each
수량
Passive 1:10 500MHz - BNC - 1 CAT II - - - 700ps
RS 제품 번호 851-3100
제조사 부품 번호PP020-1
제조사Teledyne LeCroy
₩396,373.75
Each
수량
Passive 1:10 500MHz - BNC PP020-1 - CAT I, CAT III 600 Vrms, 1500 V PP020 CAT I 1500 V, CAT III 600 Vrms 0.7ns